|
How To's Have a great writeup you would love to have posted? Post it here! |
![]() |
|
Thread Tools | Display Modes |
#21
|
|||
|
|||
![]() Ya i found it just twists in. my bad im used to seeing clips to hold em in
__________________
1994 Camaro 3.4L V6 I've had a few mods done to internals during the rebuild |
#22
|
||||
|
||||
![]() |
#23
|
|||
|
|||
![]() does anyone have anymore output pics? how wide is the low beam?
__________________
1994 Camaro 3.4L V6 I've had a few mods done to internals during the rebuild |
#24
|
||||
|
||||
![]() Dustin has a few somewhere.
Sent from my SAMSUNG-SGH-I747 using Tapatalk |
#25
|
||||
|
||||
![]() its pretty wide, the only pic i have though is the one posted above
|
#26
|
|||
|
|||
![]() now since you have done the headlamp swap i got a question. the dude on the camaroz28 forum didn't cut his bumper but cut into his radiator support. You didn't cut the radiator but cut bumper. Looking back do you think either way is a better way than the other?
Personally to me it seems better to cut your bumper than the radiator support
__________________
1994 Camaro 3.4L V6 I've had a few mods done to internals during the rebuild |
#27
|
||||
|
||||
![]() to do a halogen c10 swap you do not have to cut anything besides the headlight bar.
to do projectors you have to cut the radiator support because of the depth of the projector in the assembly. you do not have to cut the bumper at all if you prefer not to. Kyle and I wanted the bottom of the headlight to be recessed below the bumper to line up the inside of the housing to the bumper. its just a clean look compared to not cutting it. and it fits a little better under the hood when you can move it down a little |
#28
|
|||
|
|||
![]() gotcha i didn't think about mounting depth from projectors
__________________
1994 Camaro 3.4L V6 I've had a few mods done to internals during the rebuild |
|
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|