|
Drivetrain Transmissions | Clutches | Torque Converters | Driveshafts | Differential | Axles | Shifters |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]() Alrighty so I recently bought a 2002 chevy camaro v6 manual(she needs a lot of work) okay but the main problem is it shakes but not at idle and shakes really bad in third but not fourth or fifth and sincd I had some time today I took out my tranny mount and nope its solid no wiggle can anyone help me or even give me a clue at what to look at
Sent from my LG-LS993 using Tapatalk |
#2
|
|||
|
|||
![]() So I recently bought a 2002 chevy camaro v6 manual but when I bought it would shake not a whole bunch but noticeable but what threw me off is in third it makes the tranny hop and hit the tunnel but in fourth and fith shakes but not as bad so I thought tranny mount I checked and nope solid can anyone help me diagnose this
Sent from my LG-LS993 using Tapatalk |
#3
|
||||
|
||||
![]() Does it have a 2 piece drive shaft? the bushing in the middle typcially goes bad after 150K. replace it with a solid DS from a v8 steel or alum will work.
I'd look there first. |
#4
|
||||
|
||||
![]() Merged threads for housekeeping
|
#5
|
||||
|
||||
![]() I bet Dustin is right. Probably the drive shaft carrier bearing. You might wanna also check the motor mounts while you're at it. Cuz of the tunnel bump...
__________________
'94 with '98 front clip 3.4, BW T5 WC Manual 205,635 miles Shortstar Swap in the Works... |
#6
|
||||
|
||||
![]() the trans mount is probably bad too given the hopping
|
#7
|
||||
|
||||
![]() New mounts all around! There's only three of them.
__________________
'94 with '98 front clip 3.4, BW T5 WC Manual 205,635 miles Shortstar Swap in the Works... |
|
![]() |
Bookmarks |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|